Precision CNC Boring Drill Chuck

6380 Series Universal CNC Boring Chuck - HSK Style

6380 Series Universal CNC Boring Chuck – HSK Style

The 6380 Series Universal CNC Boring Chuck is designed to clamp precision drill and boring bits with high clamping power and accuracy.  When it comes to clamping, the 6380 Series utilizes a Jacobs chuck clamping system, offering superior concentricity with a maximum tolerance of 0.02mm (.0008″) at a 35mm drill length, extending from the output. Drill bits with a flat on the shank are not a problem either.  Flat shanks are clamped accurately and tightly provided the flat portion of the shank is positioned between 2 of the 3 clamping jaws as seen in the picture below. A minimum clamping depth into the adapter of 20mm is required.

6380 Series Universal CNC Boring Chuck - Clamping Flat Shaft

6380 Series Universal CNC Boring Chuck – Clamping Flat Shaft

The maximum RPM of for the 6380 Series Universal CNC Boring Chuck is 20,000 RPM.  This precision drill adapter can be used for RH or LH rotation tools and it’s comes in a range for either 1 to 13mm or 3 to 16mm, depending on requirements.  Interested in more information? Give us a call at 1-800-544-8436 or contact us now!

The Importance of Tool Holders in Precision Machining

GUHDO HSK63F Tool Holder, Collet, Collet Nut, Router Bit

GUHDO HSK63F Tool Holder, Collet, Collet Nut, Router Bit

The selection and proper use of the tool holder is almost as important as the actual cutting tool selection. The tool holder is the contact point between the machine and the tool itself so it’s integral to the integrity of the connection to the machine spindle. It’s essential that the tool is properly inserted within the collet and that it rotates through its cutting path with little to no run-out.  Ball bearing collet nuts help ensure the collet is clamping the tool properly in order to avoid loss of tool efficiency and any possible deflection from the clamping source.   Should you experience a run-out or machine crash one of the most important things to do is re-calibrate the spindle using a  run-out arbor.

The collet style tool holder used most frequently in woodworking is the HSK style tool holders,  made up of three main parts: the actual tool holder body, the collet and the collet nut.  In the case of ISO, SK and BT tool holders the retention knob (also referred to as a pull stud) is a fourth part.

HSK Tool Holder

When changing the tool it is important to setup the tooling in the proper tool changing fixture to properly secure the tool holder while installing/changing tooling .  A  torque wrench should be used to tighten the collet nut as over or under tightening can be dangerous to the machining operators, also having a negative effect on the tool and spindle due to slippage and chatter caused by a lack of uniform compression on the shaft.

HSK63F Tool Holder with Router Bit

When installing the tool shank into the collet, it is important that at least 3/4″ of the collet is filled with the tool shank to avoid imbalance, vibration, risk of tool slippage and even tool breakage. It’s important to ensure that the spirals/cutting edge is not covered by the collet as it can damage the edge. Improperly balanced tools will lead to a  poor material finish and paying close attention to accurate tool clamping increases the tool’s longevity, reduces noise from the machine and severely decreases the chances that spindle failure or damages will occur. In the case that this occurs don’t forget, calibration arbors are great tools to keep your spindle healthy after a move or tool crash.

HSK63F Tool Holder and Collet Nut