Insert Bit for Deep Pocket Cutting - Series 6236

Insert tool for use with drilling/routing deep mortise pockets in composite and solid wood.  This tool is primarily used for cutting lock pockets.  Suitable for use on solid wood and composite material. 

Recommended RPM:  12,000-18,000

Gradual Plunge Feed:  12m/minute (up/down)

Max. material removal:  8-10mm solid wood, 15mm composites

Shank modifications for Weldon Shanks available.

Insert Router Bit - Series 6217

For grooving, jointing and rebating on composite materials. Can plunge up to 1/2" diameter. Can be used on solid woods

Replacement inserts are double-sided and have a cross-groove to prevent any

slippage or movement of knife.  Up to 1/2" diameter (12mm) can plunge straight down, larger diameter designed to ramp-plunge only. 

Insert Router Bit - Series 6219

For producing rebates and shallow grooves. With plunging inserts. For use on composite and solid wood.

Ideal for door hinge and floor recess for door attachments. 

Insert Router Bit - Series 6219

For grooving, jointing & rebating, with plunging insert.  This tool can be used on both solid wood as well as composite materials.

Designed with wedges to hold the insert knives in place.  Suitable for manual and mechanical feed operation.

Insert Router Bit - Series 6224

For grooving, rebating and jointing on composite and solid materials.

Insert Router Bit - Series 6218

For use on composite and solid wood materials with TCT plunge tip. Right hand rotation.

Insert Router Bit - Series 6239

For jointing composite and solid materials. Right hand rotation.

Insert Router Bit - Series 6220

For use on composite and solid materials with offset inserts for chipbreakers.

Insert Router Bit - Series 6222

Application same as above.

Insert Router Bit - Series 6225

For use on composite and solid materials requiring finish without lines. With carbide tipped plunge point.